official web site:www.jianhua-pce.com
0086-533 7111578


Home > Knowledge > Content


Source: | Updated: May 27, 2016

Damp proof course (DPC) is a barrier of impervious material built into a wall or pier to prevent moisture from moving to any part of the building.

Following are the materials generally used for damp proofing of structures:

1) Flexible Materials:

The materials, which do not crack and deform their shape when subjected to loading, are called Flexible Materials

a) Bitumen Mastic (Mastic Asphalt)

  • It consists of asphalt or bitumen mixed with fine sand in hot state to form an impervious mass.

  • Due to this consistency it can be spread (when hot) to a depth of 2.5cm to 5cm, which sets on cooling.

  • It provides good impervious layer but special care is needed in its laying.

b) Bitumen Felts (Sheets):

  • It consists of 6mm thick sheet of bitumen prepared in rolls having width equal to that of brick wall.

c) Hot laid Bitumen:

This material is used on a bedding of cement concrete or mortar.

  • This should be applied in two layers at the rate of 1.75kg/m2 of the area.

d) Metal Sheets:

  • Metal sheets of Copper, Aluminium, or Lead are used to prevent dampness, but they are costly.

  • Sheets of these materials are used throughout the thickness of the wall.

  • The sheets of Lead are laid over Lime Mortar and not with Cement.

  • Mortar due to the chemical reaction of Cement over the Lead.

  • The sheets of metal should be coated with asphalt.

  • The thickness of the sheets should not be less than 3mm.

2) Rigid Materials:

  • The materials, which do not resist transverse stresses and cracks when subjected to sever loading, are known as Rigid Materials.

a) Rich Concrete

  • 1.2cm to 4cm thick layer of Rich Concrete (1:2:4) painted with two coats of hot bitumen is used as horizontal D.P.C.

  • It also prevents the moisture penetration by capillary action.

  • These layers are laid where the damp is not excessive.

b) Mortar:

  • 2cm thick layer of Rich Cement and Sand Mortar (1:3) is applied on the inner face of external wall.

  • This is a vertical D.P.C.

  • The surface is than painted with two coats of hot bitumen.

c) Bricks:

  • Over burnt or dense bricks in one or two layers can be used as cheap and effective DPC.

  • They are laid in Rich Cement and Sand Mortar (1:3).

  • Bricks are rarely used as DPC except in cheap houses.

d) Stones or Slates:

  • Two layers of stone slabs or slates laid in Lime, Cement and Sand Mortar (1:1:6) make a best DPC.

  • They can also be laid in Cement Sand Mortar.

  • It is used where a good quality of stone is easily and cheaply available.

Contact Us
Address: Wangzhu Industrial Zone, Linzi District, Zibo City, Shandong, China
Tel: 0086-533 7111578
Fax: 0086-533 7114227
Home | About Us | Products | News | Knowledge | Contact Us | Feedback | Mobile | XML